Installation

Installation Method 1: Self-tapping Screws 

1. Locate the area on your dash that you will be installing your mount. Be sure to consider entering and exiting the vehicle, as well as the action of a quickdraw.  

1. Peel off the tape seal. 

1. Place the mount flush against the area you are mounting it with the slide retainer end down. 

1. Screw in upper righthand corner screw first, then screw in the lower left. Repeat the same process with the other two screws.  

1. You may now use your mount to safely and securely transport your weapon and always be At The Ready. 

 

Installation Method 2: 3M Primer 94 

1. Locate the area where you will be installing your mount. Be sure to consider entering and exiting your vehicle, as well as the action of a quickdraw. 

1. Clean the area with an alcohol wipe or ½ water, ½ alcohol solution to free the area of dust and oils. Wait until alcohol evaporates before moving on. 

1. Shake the primer tube for about 10 seconds. Crack the tube in the middle and shake again. 

1. Apply the primer to the area you are mounting to. Use all of the primer in the tube. Wait 5 minutes before moving on. 

1. Unpeel the tape seal and place the mount flush against the area you are mounting to with the slide retaining end down. 

1. Press firmly for 1 minute to ensure even application. 

1. Let cure for 72 hours before holstering your EDC to ensure secure adhesion. 

1. After 72 hours, you may now use your mount to safely and securely transport your weapon and always be At The Ready. 

 

ATTENTION: When installing our mounts in your vehicle, you must use either the self-tapping screws or the primer application for optimal adhesion. Opting to disregard this recommendation with VOID your lifetime warranty.